Benchmark the performance of Flink on Arm servers
Introduction
Setup and Configure Flink
Setup and Config Nexmark
Benchmark Flink with nexmark-flink on Arm
Next Steps
Benchmark the performance of Flink on Arm servers
Review frequently asked questions
These FAQs were drafted with an approved AI-assisted workflow and reviewed by Arm contributors before publication. Human technical review remains part of the process so the final page reflects engineering rigor, accuracy, and Arm editorial standards.
Flink requires JDK 11, and Nexmark requires JDK 1.8.x or higher. Use JDK 11 to satisfy both requirements.
Run the scripts on the master node. Use paths such as
~/flink-benchmark/flink-1.17.2/bin/start-cluster.sh and ~/flink-benchmark/nexmark-flink/bin/setup_cluster.sh.Set
jobmanager.rpc.address in flink-conf.yaml and nexmark.metric.reporter.host in nexmark.yaml to the JobManager address. You can use the JobManager IP or the default localhost:8081 when the components run on the same host.Ensure
sshd is running because the Flink and Nexmark scripts use SSH to manage remote components. Start or enable the service before continuing.Pass a comma-separated query list to
run_query.sh, such as bash ~/flink-benchmark/nexmark-flink/bin/run_query.sh q1,q2. The script runs the selected queries and reports their benchmark results.