Build and debug an embedded Rust app with Arm Development Studio
Introduction
Install tools and build an example
Run the example on FVP and debug with Arm Debugger
Next Steps
Build and debug an embedded Rust app with Arm Development Studio
Review frequently asked questions
These FAQs were drafted with an approved AI-assisted workflow and reviewed by Arm contributors before publication. Human technical review remains part of the process so the final page reflects engineering rigor, accuracy, and Arm editorial standards.
Build for Armv7-M with the
thumbv7m-none-eabi target. The run command uses output under target/thumbv7m-none-eabi.Use the
FVP_MPS2_Cortex-M3.exe model included with Arm Development Studio. The example run command invokes this executable.Point
-a to the built binary under target/thumbv7m-none-eabi/debug/examples/armds. Ensure that the path matches your build output directory and example name.Add
-C fvp_mps2.mps2_visualisation.disable-visualisation=1 to the FVP command. This affects only visualization and doesn’t change FVP behavior.The console shows output similar to “Total sum to 1 is 1” and “Calculated sum is 1.” The application then runs to completion on the FVP.